7.5 Kw Motor Power Stud And Track Roll Forming Machine Driven By Chain
Parameters
| | Items | Specifications |
| Material of coil | Thickness | 0.27-1mm galvanized steel |
| De-coiler | Weight | 3 ton manual |
| Forming system | Rolling Speed | 0-10m/min |
| | Embossing | At sides |
| | Roller Stations | About 13 stations forming |
| | Roller Material | Cr40 Steel with quenching |
| | Shaft Material | 45# Steel Diameter 60mm shaft |
| | Motor Power | 7.5 kw |
| | Hydraulic cutting Power | 4 kw |
| Cutting system | Material of cutting | CR12 with quench treatment |
| | Hardness | HRC58-62 |
| | Tolerance | +-1.5mm |
| | Cutting blade | 1 set of cutting blade |
| Electrical control system | Electric Source | 380V, 60HZ,3 phase |
| | Control System | PLC |
| | Weight | About 3 tons |
| | Way Of Drive | 1 inch single chain |
| | Size of machine | Length 5500mm* Width 600mm* Height 800m |
Machine list
| Machine list | 3 ton passive de-coiler | 1 set |
| | Main roll forming machine | 1 set |
| | Punching device | 1 set |
| | Cutting device | 2 sets |
| | PLC Control box | 1 unit |
| | Hydraulic station | 1 unit |
| | Out table | 2 units |
| | Safety cover | 1 unit |
Advantages
1. We are design the one unit one machine, the control box and the hydraulic station for the cutting are all
put under the bedding, when you get the machine, the machine is one unit, no need to assemble and
connect the complicate cable of the machine, you only need to connect one main cable, then the machine
is working.
2. the touch screen is hang over, it is not under the floor.
3. the accuracy of our machine is -/+0.5-1mm.
4. the roller is solid and electroplated, which will not have rust.
5. the material are all national standard and cutter will not have burr.
6. the board are all milled and polished.
7. the roller is solid and galvanized
8. our machine is a little heavy than others, because it have more stands
Machine pictures
Products
Product Tags:
|
|
7.5 Kw Motor Power Stud And Track Roll Forming Machine Driven By Chain Images
|
